Connect the lamp with the power cord to a power source.
The timer has 3 curing modes: 30s, 60s and 90s.
After starting the lamp, you can select the appropriate timer button so that the lamp goes into standby mode and starts counting down the selected curing time (each product has its own specific curing time).
After pressing the selected timer button again during operation, the lamp will go into standby mode.
After inserting your hand without selecting the operating time, the motion sensor will start the lamp automatically in the 90s mode.
Remembering the selection of working times - the 30s, 60s, 90s buttons have a memorizing function. AFTER selecting a certain time, the lamp remembers the choice and when the next time you put your hand in, the lamp starts with the previously selected time.
Timing on the LED display - after selecting the operating time between 30s, 60s, 90s, the time runs backwards from the selected time to 0. In case of automatic activation by the motion sensor, the time is counted from 0 to 90s.
After finishing work, disconnect the lamp from the power source.